Bashar Mohammed Salih
Research InterestsRenewable Energy
Power Electronics
Electrical Power Enginnering
Gender | MALE |
---|---|
Place of Work | Technical Engineering College/ Mosul |
Position | Teaching |
Qualification | Master |
Speciality | Electrical Engineering |
basharms_tecm@ntu.edu.iq | |
Phone | 07709938391 |
Address | Residential Complex/Northern Technical University, Ninawa, Mosul, Iraq |
90 +
Contribution to examination committees
90 +
Contribution to the Administrative Committees
90 +
Teaching for the initial stages of study
80 +
Practical teaching in graduate studies
80 +
Publishing many scientific research papers in international containers
80 +
Supervising the graduation projects of undergraduate students
Skills
Electrical Drive (80%)
Renewable Energy (80%)
Power Electronics (70%)
Engineering Management (60%)
Computer Applications (85%)
Electric Machine Lab. (80%)
Academic Qualification
M.Sc. in Electrical Engineering and Aircraft Machinery
Dec 7, 1997 - PresentWorking Experience
Electrical engineering [Lecturer]
Jan 1, 2005 - PresentLab. Work [Lab. Supervisor]
Jan 1, 2005 - PresentPublications
An intelligent differential protection of power transformer based on artificial neural network
Jan 2, 2022Journal Bulletin of Electrical Engineering and Informatics
publisher International Research Publication House
Issue 1
Volume 11
This paper describes the application of artificial neural network (ANN) techniques for protecting small power transformer 2 kVA (Terco type). ANN network trained according to the primary and secondary currents data under NN tool, this network performs as a function of differential protection relay. Symmetrical and unsymmetrical faults are analyzed using Matlab environment. ANN network senses the difference in the internal current of both transformer sides and sending a trip to the circuit breaker (CB) at moment of fault occurrence. All the voltages and the currents waveforms affected with the fault and the response time increased according to this technique. Finally, the trip signal and the quick disconnect time were improved according to ANN technique.
Differential Relay Protection for Prototype Transformer
Jan 6, 2021Journal PRZEGLĄD ELEKTROTECHNICZNY
publisher Society of Polish Electrical and Electronics Engineers
Issue 6
Volume 2021
This paper represents the differential protection relay that used to protect the prototype-Terco power transformer. Matlab/Simulink is used to simulate the protection system. The power differential protection algorithm has been simulated and tested on a 2KVA power transformer under different faults. During normal operating conditions, current will flow through all phase of the power transformer within predesigned values which are appropriate to these elements rating and the faults can be classified as the flow of a massive current. the results signify suitable completion.
PI controller for DC motor speed realized with simulink and practical measurements
Jan 3, 2020Journal International Journal of Power Electronics and Drive System (IJPEDS)
publisher Institute of Advanced Engineering and Science (IAES)
DOI 10.11591/ijpeds.v11.i1.pp119-126
Issue 1
Volume 11
This article describes the methodology of speed control by understanding control method of DC motor, definitely, armature and field resistances with additional to armature voltage control methods. The speed of DC motor is controlled PI controller as donor in this work. Using Matlab simulation and practical measurements, Terco DC motor speed control is achieved in this work. The results that obtained from Matlab simulation circuit is appeared approximately similar that obtained by practical connection.
Partial Discharge Measurement in Solid Dielectric of H.V Cross-Linked Polyethylene (XLPE) Submarine Cable
Jan 2, 2020Journal Indonesian Journal of Electrical Engineering and Computer Science
DOI 10.11591/ijeecs.v17.i3.pp1578-1583
Issue 3
Volume 13
A partial discharge described as a non-linear electrical break-down event that happened in a section of insulating area between two conduct which are at different potentials the damage of the insulating material, these conductors have a different insulating material potential of damage, under AC voltage discharge interval process. In this paper, we propose a Matlab/Simulation software. A detailed analysis of the partial discharge (PD) signal in the underground electric power conductor performed for monitoring, and investigation of numerous effects associated with the partial discharge event, such as heat, phonic and electrical. Thus, to gain the important data of the insulating material status
Partial Discharge Measurement in Solid Dielectric of H.V Cross-Linked Polyethylene (XLPE) Submarine Cable
Jan 2, 2020Journal Indonesian Journal of Electrical Engineering and Computer Science
DOI 10.11591/ijeecs.v17.i3.pp1578-1583
Issue 3
Volume 13
A partial discharge described as a non-linear electrical break-down event that happened in a section of insulating area between two conduct which are at different potentials the damage of the insulating material, these conductors have a different insulating material potential of damage, under AC voltage discharge interval process. In this paper, we propose a Matlab/Simulation software. A detailed analysis of the partial discharge (PD) signal in the underground electric power conductor performed for monitoring, and investigation of numerous effects associated with the partial discharge event, such as heat, phonic and electrical. Thus, to gain the important data of the insulating material status
DC Motor Speed Control Using PID Controller Implementation by Simulink and Practical
Jan 1, 2018Journal International Journal of Electrical Engineering
publisher International Research Publication House
Issue 11
Volume 1
In this research, speed control of DC motor (Terco Company) type is implementation by Matlab/Simulation and practical. A comparison is made by Simulink modeling circuit and practical connection. The results obtained from simulation are approximdtly similar to that obtained by practical. Also the dynamic behavior is studied.
Modeling and simulation of 1.5 MW wind turbine
Jan 1, 2018Journal Int. Journal of Applied Engineering
publisher International Research Publication House
Issue 10
Volume 13